Multilac


	Field of Application:			Properties:
	Multilac Hammer Finish is specially designed for metal surfaces. It will protect and also give a hammer tone texture finish to your paint work			Multilac Hammer Finish is a low solid, synthetic resin-based paint

	Technical Data:			Solid-content:
	Basic characteristics at 20 °C:			approx. 35-40% by weight

	Flash point:			Vehicle:
	above 65 °C.			Chemical inter neutral resin

	Degree of Gloss:			Colours:
	Min 30 at 85 °C angle			Refer to shade card.

	Storage:			Safety Advice:
	Store at room temperature between 10 C- 48 °C			Keep out of the reach of children. In case of contact with eyes, rinse immediately with plenty of clean water.

	Waste Removal:			Packaging:
	Materials and all related packaging must be disposed of in a safe way in accordance with the full requirements of the local authorities.Particular attention should be made to removing wastage from site in compliance with standard construction site procedures.			1litre, 4 litres tin cans and 200 litres drums.

Method of Application:
	Preferably by brush or roller. Can also be sprayed.

Cleaning of tools:
	Brush and other tools must be cleaned with white spirit immediately.

Covering Capacity:
	16-18 Sq.m / litre (depending on surface )

Drying time :
	Touch dry - 15 min Hard dry- 2 hours

Suitable Surface and their Preparation
	The surface must be dry, free from dust and other such separable substances that may prevent good adhesion. The type of surface-preperation depends on the available surface and it's condition. Surface must be allowed to dry and cleaned prooerly. Do not apply on humid conditions. If the surface is wet and moisture prevails the paint will not give a bright finish.

Technical Assistance:
	As it is imposible to list herein the widevariety of substrates and their specific problems, please request our technical assistance in case of queries.

Please Note:
	All suggestions and application instructions herein are based on our latest technical experience. Due to the wide variety of individual project conditions, we cannot be held responsible for their content.