Multilac


	Field of Application:			Properties:
	Micron NC Sanding Sealer is a NC based high viscous and quick drying sealing primer for all kinds of wooden surfaces.			Micron N. C. sanding sealer is an ample, matt and quick drying clear cellulose sealer which renders very fine sanding properties shortly after application. Gives a very smooth & even surface after sanding.

	Technical Data:			Solid-content:
	Basic characteristics at 20 °C:			approx. 40% by weight

	Flash point:			Vehicle:
	above 65 °C.			Special Alkyd in Hydrocarbon solvents.

	Degree of Gloss:			Colours:
				Clear

	Storage:			Safety Advice:
	Store at room temperature between 10 C- 48 °C			Keep out of the reach of children. In case of contact with eyes, rinse immediately with plenty of clean water.

	Waste Removal:			Packaging:
	Materials and all related packaging must be disposed of in a safe way in accordance with the full requirements of the local authorities.Particular attention should be made to removing wastage from site in compliance with standard construction site procedures.			200ml, 500ml, 1litre and 4 litre cans. 200 litres drums.

Method of Application:
	By brush or spray gun.

Cleaning of tools:
	Brush and other tools must be cleaned with soap water immediately.

Mixing ratio :
	1 part of sanding sealer with 2 parts of Macksons N.C. Thinner ( by volume)

Covering Capacity:
	3-15 Sq.m / litre (depending on method of application )

Drying time :
	Touch dry- 10 min Sanding dry- 30 - 60 min

Suitable Surface and their Preparation
	The wooden surface must be dry, free from dust and other such separable substances that may prevent good adhesion. The type of surface-preperation depends on the available surface and it's condition.

Technical Assistance:
	As it is imposible to list herein the wide variety of substrates and their specific problems, please request our technical assistance in case of queries.

Please Note:
	All suggestions and application instructions herein are based on our latest technical experience. Due to the wide variety of individual project conditions, we cannot be held responsible for their content.